PureMessage for Windows/Exchange: how to install when you have an Exchange 2007 server

  • Article ID: 24404
  • Updated: 25 Aug 2011

PureMessage for Windows/Exchange, version 2.6.1, is not supported on Exchange 2007. In order to protect your Exchange 2007 servers from inbound viruses, spam and content threats, you must install PureMessage on an alternative Windows computer.

Sophos recommends that you install PureMessage on a 32-bit Windows 2003 Server, configured as described below. Details of other versions of Windows which support PureMessage are available in the PureMessage startup guide.

Sophos expects to release a version of PureMessage later this year, which is supported on Exchange 2007. Existing customers will be able to upgrade to the new version for no additional cost.

What to do

1. Install Internet Information Services and the Windows SMTP service

These components are required on the computer on which you are going to install PureMessage. If they are not already installed, they can be installed using the 'Add/Remove Windows Components' wizard in 'Add/Remove Programs' in 'Windows Control Panel'. For more information on these services and how to install them, refer to your Windows documentation.

2. Configure the Virtual SMTP Server

On the computer on which you are going to install PureMessage, open the 'Internet Information Services (IIS) Manager' window, and in the left hand pane, under 'Virtual SMTP Server'|'Domains', add a 'Remote Domain' to forward email to your Exchange server.

Refer to the Microsoft knowledgebase article How To Configure a Remote Domain for an Internet Information Services SMTP Mail Relay Server in Windows Server 2003 for information on how to do this.

3. Configure Incoming SMTP email

Configure the forwarding of incoming SMTP traffic, to the virtual SMTP server on this Windows computer. Consult your Windows or other documentation for details of how to do this.

4. Install PureMessage 2.6.1

Follow the instructions in the PureMessage startup guide. Both 'Administrative Console' and 'PureMessage Service' components need to be selected

Additional Information

Refer also to the following Microsoft knowledgebase articles:

'How To Test SMTP Services Manually in Windows Server 2003' http://support.microsoft.com/kb/323350

'HOW TO: Set SMTP Security Options in Windows Server 2003' http://support.microsoft.com/kb/324285

 
If you need more information or guidance, then please contact technical support.

Rate this article

Very poor Excellent

Comments